Curtis 3000 Manual de Instalação descarregar pdf (Página 5)

1. Mount the Plow Lights and Harness

Plug Holder (as shown in figure E)

using hardware supplied with the

Plow Light Kit.

2. Secure the Harness to the Lift Frame

(as shown in figure E) using the sup-

plied Harness Clips, Bolts, Nuts and

Wire Ties .

A. If the Harness and Lift Cylinder

Hose are not pre-wrapped together

with Hose Wrapping, Tie them to-

gether using 3 Wire Ties 4” apart

starting at the “A” Frame exit.

B. Plug the Plow Light Connectors

into the Harness & Wire Tie to the

Lift Frame Hoop at each plug.

C. Wire Tie the pigtail from each plow

light to the Upper Plow Light

Brackets of the Lift Frame.

D. Tie both branches of the Harness

to the Hoop just above the Driver’s

side lower Plow Light Bracket.

E. Place a Harness Clip over the Har-

ness and attach using a 1/4” Bolt

and Lock Nut to one of the three

holes (depending on the position of

the Side Plates) at the rear of the

Driver’s side Lift Frame post.

F. Place a Harness Clip over the Har-

ness & attach using a 1/4” Bolt &

Lock Nut to the front tab of the

Driver’s side Lift Frame post.

Section E

1. Place vehicle on a level surface 25 feet in front of a matte-white screen, such as a garage door.

The screen should be perpendicular to both the ground and the vehicle centerline.

2. The vehicle should be ballasted for snow plowing with a driver. The snowplow blade should be in

place and in the raised position.

3. Below are points listed by the Society of Automotive Engineers (SAE) pertinent to headlamp

aiming in specification #SAE J599.— Remove ice or mud from under fenders.— See that no tire is

noticeably deflated.— Check springs for sag or broken leaves. — Check functioning of any “level-

ride” control.— Check Plow Light lens and aiming system for loose or broken parts.— Check bulbs

for burnouts, and proper beam switching.— Stabilize suspension by rocking vehicle sideways.

4. Mark or tape the vertical centerline of the Plow Lights and the centerline of the vehicle on the screen.

Mark or tape the horizontal centerline (distance up from floor) of the Plow Lights on the screen.

5. The correct visual aim for Type 2 Plow Lights (see number on face of sealed beam) is with the top

edge of the high intensity zone of the lower beam below the horizontal centerline and the left edge of

the high intensity zone on the vertical centerline (see diagram below).

Vertical Centerline Ahead

of PS Headlamp

Align With Vehicle

Centerline

Vertical Centerline Ahead

of DS Headlamp

Screen Located 25 Feet

From Headlamps

High Intensity Zone For Type 2

(Sealed Beam) Headlamps on Low Beam

Plow Light Beam Aiming

CAUTION

Always ensure that headlamps are

adjusted properly.

3. Adjust the Plow Lights using the steps described below in the sec-

tion entitled “Plow Light Beam Aiming”.

NOTE: The routing of the Harness and location of each Harness Clip

& Wire Tie is very important so that it will “flex” properly when the

plow is raised and lowered. Failure to properly route and secure the

Harness may result in severe damage to it

Fig. E

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

Curtis 3000 Manual de Instalação Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Sopradores de neve Curtis 3000